Tech Support
Autel AL319 OBD2 Code Reader – Editor’s Pick. Autel calls this device a “plug and play” scanner. C#-Library to read/write data from/to a car through an ELM327-/STN1170-Adapter. OBD.NET.Common - NetStandard 1.4 Library for platform independent stuff. Serial This cable has a 12 pin OBD1 connector shell to plug in under your cars dash to interface to your cars ECM. This cable is the most convenient to use if your car is equipped with the 12 pin connector style, as it allows you to just feel under the dash to plug it in. This item can be used with TunerPro RT, TTS Datamaster, TunerCat reflash for LT1, WinALDL, and EFI Live V4(OBD1). $80.00 'BURN2 Chip Programmer' USB Chip Programmer works with the AT29C256, 27SF512, and AM29F040 chips. Self-powered from the USB port, so no power adapter is needed! Burner can also be used to read stock GM memcals using the HDR1. Toyota Obd1 Serial Interface For Arduino 6/24/2018 admin ArduinoHondaOBD An arduino code that reads Honda OBD Protocol and translates it to ELM327 protocol.
Toyota Camry 2015 2016/2017 Years 8A All Keys Lost
Toyota Corolla 8A All Keys Lost
Toyota Obd1 Serial Interface Adapter 3.0
Toyota High Lander 8A All Keys LostToyota Hilux 8A All Keys Lost
Toyota Levin 8A All Keys LostToyota Prado 2017 2018 8A All Keys Lost
Toyota Obd1 Serial Interface Adapter Tool
Toyota RAV4 8A All Keys LostDemo Guide: Toyota 8A all keys lost done with VVDI2 + 8A control box cable
Here shows the procedure on how to program new key when Toyota 8A all keys lost with Xhorse VVDI2 + 8A control box cable.
1. Disconnect the BAT+ to protect the connector to avoid short circuit.
2. Connect the fuse box.
- Unplug the relay, if the reply location is not as the same as that in this video, please contact the support.
- Plug the J3 harness interface.
3. Connect the steering wheel ignition harness.
Unplug the ignition plug, insert J5 ignition plug.
4. Plug into the OBD2 port of the car, connect the Toyota 8A all keys lost adapter with VVDI2, connect the car battery.
5. Put the VVDI2 super chip into the Xhorse VVDI2.
6. To generate the starting chip by operating the option in the VVDI2.
7. Restore the original car's harness (otherwise the fuse box and devices will be burned after directly starting.)
8. Test the starting chip.